Hello again all,
This is further to an earlier topic - stalls when putting in gear: http://www.delica.ca/forum/stall-when-p ... 12400.html
My mechanic first changed the fuel filter. When that didn't help, he looked a little deeper and found the rocker shaft was broken in two places!
That was replaced, and the van ran great for about 30 km... then it suddenly lost power again and now is in bad shape again. Idling rough, sounds like it is not firing all cylinders. I am concerned the rocker shaft is going to break again / has broken again because of some underlying cause that I can't identify.
Any ideas?
Low power / broken rocker shaft
- professorpunishment
- Posts: 24
- Joined: Sun Sep 09, 2007 11:00 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Delica Chamonix 1992 - Diesel
- Location: New Brunswick
- jessef
- Posts: 6459
- Joined: Tue Feb 26, 2008 1:27 pm
- Vehicle: JDM flavour of the month
- Location: Vancouver
- Location: Vancouver, BC
Re: Low power / broken rocker shaft
leakdown and compression test first to see if it's breathing inside
- FalcoColumbarius
- Site Admin
- Posts: 5983
- Joined: Tue Jan 22, 2008 1:55 pm
- Member's Photo Album: http://www.delica.ca/Photos/index.php?cat=11103
- Vehicle: Delica; Chamonix GLX ('92 P25W)
- Location: North Van, BC, eh?
Re: Low power / broken rocker shaft
Have you checked the timing belt and tensioner?professorpunishment wrote:Hello again all,
This is further to an earlier topic - stalls when putting in gear: http://www.delica.ca/forum/stall-when-p ... 12400.html
My mechanic first changed the fuel filter. When that didn't help, he looked a little deeper and found the rocker shaft was broken in two places!
That was replaced, and the van ran great for about 30 km... then it suddenly lost power again and now is in bad shape again. Idling rough, sounds like it is not firing all cylinders. I am concerned the rocker shaft is going to break again / has broken again because of some underlying cause that I can't identify.
Any ideas?
Falco.
Sent from my smart pad, using a pen.
Seek Beauty...
Good Ship Miss Lil' Bitchi
...... Vision without action is a daydream. Action without vision is a nightmare. ~ Japanese Proverb
Seek Beauty...
...... Vision without action is a daydream. Action without vision is a nightmare. ~ Japanese Proverb
- professorpunishment
- Posts: 24
- Joined: Sun Sep 09, 2007 11:00 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Delica Chamonix 1992 - Diesel
- Location: New Brunswick
Re: Low power / broken rocker shaft
Just an update on this, in case anyone else ends up in the same boat:
Problem was that broken rocker shaft caused a crack in one of the rocker arms, so after a few kms of use, a rocker arm broke. New rocker arms installed, and now runs like a top!
Problem was that broken rocker shaft caused a crack in one of the rocker arms, so after a few kms of use, a rocker arm broke. New rocker arms installed, and now runs like a top!
- FalcoColumbarius
- Site Admin
- Posts: 5983
- Joined: Tue Jan 22, 2008 1:55 pm
- Member's Photo Album: http://www.delica.ca/Photos/index.php?cat=11103
- Vehicle: Delica; Chamonix GLX ('92 P25W)
- Location: North Van, BC, eh?
Re: Low power / broken rocker shaft
Glad everything worked out for you, Professor, did it set you back much?
Falco.
Falco.
Sent from my smart pad, using a pen.
Seek Beauty...
Good Ship Miss Lil' Bitchi
...... Vision without action is a daydream. Action without vision is a nightmare. ~ Japanese Proverb
Seek Beauty...
...... Vision without action is a daydream. Action without vision is a nightmare. ~ Japanese Proverb
- professorpunishment
- Posts: 24
- Joined: Sun Sep 09, 2007 11:00 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Delica Chamonix 1992 - Diesel
- Location: New Brunswick
Re: Low power / broken rocker shaft
Yes, yes it did. The mechanics here were good about it -- didn't charge me the total number of hours they put into it, just trying to figure out the problem in the first place -- but the rocker shaft job was $1000 and the rocker arms $600.