Delica Canada | Mitsubishi Van Club

That's one heavy trailer! My entire caravan weighs about 1500-2000lb (depending on how much beer I've put in it). Still, as you say, well within the truck's capability.

Spring has arrived - Subaru is parked for the summer and the Strada hits the road again! Gave the truck a once over, oil change, greased all that needs to be greased, drained some water out of the fuel filter and we're rolling.

Finally found a headache rack and boxrails for the truck. Of course...

Hey, How's the Strada? I would love to see any pics of your intercooler install. I keep thinking about it, have taken measurements a few times but have yet to take the plunge! Ralph in Winnipeg

I bled a bit of air out yesterday from the filter and truck started and ran like a champ. Hoping this is the last bleeding necessary.

Rebuild kits are quite rare apparently. Luckily, the 3/4" bore slave cylinder is very common. Bought a cheap Mazda slave cylinder and slipped the piston into the stock Strada one and we are good to go.

Saw you on the north perimeter around 4pm today!

Yes there is a valve that control temperature of the HVAC.Cold=cut the flow of coolant thru the core..Hot=coolant is flowing thru the heater core.
That valve is behind the top of the dash,over the gas pedal.

It always turns out to be a big job!!!

there was nothing wrong with the clutch/components other than needing a new clutch due to age. (it was not the cause of my symptoms)

The transmission was my problem. majority of the bearings were toast, including one where it was pretty much running race on...

Trucks are still handy to haul stuff...
...I'd take those over the Nissan Frontiers any day. Tacoma, not so sure.
Between the mid-sized trucks, I definitely preferred the looks of the Tacoma over the Frontier. That being said, I preferred the look of the Nissan Titan over the Toyota Tundra - the...

'92? Look for Montero replacements - they could be the same.

I don't know how different the drive train of the Strada/L200 was from the Pajero/Montero and Delica, or which parts differ.

You can aslo try to give advance on the fuel pump timing.That will compensate the wear of
the cam plate but will not do anything for the pressure.
Give advance on the timing and you will see a difference.The timing on our truck is 7 degrees,try
for 5 degrees,like on 4d55,or even lower,until you...

Hi DC,

I bought a engine protector called Siselco this is a real-time monitor of parameters such as high temp, low temp, low oil pressure, coolant level and low voltage. The temp is measured directly on the cylinder head, and have programmable alarms and cutting engine.. I hope whith this device,...

Ok,I've passed winter with the lift pump to compensate for wear of the rotor head of the injection pump and i could say that
a lift pump make no difference.The best way to resolve many of the smoking,chugging,bumping,etc... is to rebuild the IP with new seals and rotor head.

I don't know why it is...

:-D

The glow plug controller is on the passenger side(left side of the cab) just beside the glovebox,bolted
on the pillar where the door hinges are fixed,just over a plastic trim.
It's a small square metal box with a connector on it,6 or 8 wire,don't remember.

I know it's not a bad ground with the module, as I grounded it elsewhere to test that.

I can test the single headlight theory when I get my truck back from my brother.

If your module is under the hood, could you take note which wires are being used. I might just try mounting it elsewhere to see...