The install today was with a newer model of the system we run; SVD Enterprises converter in a Rabbit. Practice for an upcoming Delica owner.
Showcasing todays WVO install
Moderator: BCDelica
-
BCDelica
- Posts: 1808
- Joined: Tue Jul 18, 2006 4:12 pm
- Member's Photo Album: http://www.delica.ca/Photos/index.php?cat=10008
- Vehicle: WVO Powered Tuk Tuk
- Location: Central Van Isle
- Location: Somewhere with plenty of sun
Showcasing todays WVO install
Wanted to show off some neat and tidy WVO conversion work!
The install today was with a newer model of the system we run; SVD Enterprises converter in a Rabbit. Practice for an upcoming Delica owner.
The install today was with a newer model of the system we run; SVD Enterprises converter in a Rabbit. Practice for an upcoming Delica owner.
- Attachments
-
- Wiring by BCDelica
- arvw.JPG (361.46 KiB) Viewed 2951 times
-
- Left to right:Heat exchanger with 12v heat and solenoid valve, fuel return valve solenoid, thermocoupled heated filter.
- arvw2.JPG (313.16 KiB) Viewed 2943 times
Call me BCDelica-less-
after oil
- Posts: 1436
- Joined: Mon Feb 11, 2008 7:01 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 cham-reimo poptop L300. 78MB240D
- Location: on the road
- Location: occupied coast salish territory aka powell river
Re: Showcasing todays WVO install
heres some photos of the install cleaned up and all finished:
Image Hosting
Image Hosting
Image Hosting
Image Hosting
nice work BCDelica!
Image Hosting
Image Hosting
Image Hosting
Image Hostingnice work BCDelica!
-
BCDelica
- Posts: 1808
- Joined: Tue Jul 18, 2006 4:12 pm
- Member's Photo Album: http://www.delica.ca/Photos/index.php?cat=10008
- Vehicle: WVO Powered Tuk Tuk
- Location: Central Van Isle
- Location: Somewhere with plenty of sun
Re: Showcasing todays WVO install
It is a good install, but IMO that wiring is roughly 50% tidy. But that's my install practice, after it's tested and tried on a few long runs, pull most wires from where they connect and route then pretty. Yes I sound defensive, but each wire was cut to an even length during..
We'll be doing it nice before any WVO/bio fuel shows I hope??
We'll be doing it nice before any WVO/bio fuel shows I hope??
Call me BCDelica-less-
after oil
- Posts: 1436
- Joined: Mon Feb 11, 2008 7:01 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 cham-reimo poptop L300. 78MB240D
- Location: on the road
- Location: occupied coast salish territory aka powell river
Re: Showcasing todays WVO install
update:
stupid VW only circulates water through the heater core when the lever is pushed over to hot. it opens a valve, you can see it in the photo, its in the middle of the top heater hose with a cable going to it. i gotta switch the T around with the valve.
stupid VW only circulates water through the heater core when the lever is pushed over to hot. it opens a valve, you can see it in the photo, its in the middle of the top heater hose with a cable going to it. i gotta switch the T around with the valve.