Front blower resistors for fan speed

Mitsubishi Delica L400 production commenced in 1994 -- After much anticipation, the L400 arrived on Canadian Soil in 2009!
Post Reply
TrickyNicky
Posts: 11
Joined: Thu Apr 10, 2014 11:28 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica Window Shopping
Location: Vancouver, BC

Front blower resistors for fan speed

Post by TrickyNicky » Wed Apr 13, 2016 10:43 am

The previous owner bypassed the blower resistor pack and I would like to get my fan speeds back. The resistor pack is below/behind the glove box. It is a black 3cmx10cm rectangle held in by two screws. There is a single electrical clip with 4 wires coming out of it. I need to know what wire goes where as the previous owner cut the clip off and bypassed it. My wire colours are 2 thick black and 2 thin blue. One of each with a stripe.

This favour should not require any dis-assembly of the van. Just look below your glove box and snap a pic of the wire colours.

If someone wants to be extra helpful could you check the resistance between the pins on the resistor bank itself?

Thanks in advance.
Attachments
IMG_1974.JPG
IMG_1974.JPG (47.96 KiB) Viewed 547 times
IMG_1973.JPG
IMG_1973.JPG (29.25 KiB) Viewed 547 times
FullSizeRender.jpg
FullSizeRender.jpg (89.31 KiB) Viewed 547 times

Post Reply

Return to “L400 Technical”