Where to get bushings? L300

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
User avatar
lrp374
Posts: 928
Joined: Sun Nov 23, 2008 9:56 pm
Vehicle: 91 Super Exceed
Location: Kamloops

Where to get bushings? L300

Post by lrp374 » Fri Oct 11, 2019 8:14 am

Are these the ones your looking for?
Attachments
Trans Mnt.jpg
Trans Mount
Trans Mnt.jpg (27.45 KiB) Viewed 374 times

User avatar
deskinthewoods
Posts: 147
Joined: Thu Mar 08, 2018 10:35 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1991 L300 Star Wagon named "Wilson"
Location: Wakefield, Québec

Where to get bushings? L300

Post by deskinthewoods » Fri Oct 11, 2019 2:08 pm

Hmmmm,... those might just be them! I’ll go climb under and have a good look around tomorrow...
My dad used to say,"If you can read, you can do anything!"

User avatar
deskinthewoods
Posts: 147
Joined: Thu Mar 08, 2018 10:35 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1991 L300 Star Wagon named "Wilson"
Location: Wakefield, Québec

Where to get bushings? L300

Post by deskinthewoods » Tue Oct 15, 2019 3:58 am

These are for the Automatic transmission. I found the correct ones on Amayama.com. The manual transmission exploded view is below the A/T view , which I had not noticed. :roll:
My dad used to say,"If you can read, you can do anything!"

User avatar
deskinthewoods
Posts: 147
Joined: Thu Mar 08, 2018 10:35 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1991 L300 Star Wagon named "Wilson"
Location: Wakefield, Québec

Where to get bushings? L300

Post by deskinthewoods » Fri Oct 18, 2019 8:26 am

Just wondering, has anyone cast their own bushings?
My dad used to say,"If you can read, you can do anything!"

thelazygreenfox
Posts: 865
Joined: Tue Jun 08, 2010 7:21 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 99 white Hi roof gas Chamonix
Location: Coquitlam B.C.
Location: coquitlam canada

Where to get bushings? L300

Post by thelazygreenfox » Sun Nov 24, 2019 11:09 pm

Ebay sells a lot of delica bushings. The ones supplied by Febest (Chinese but w a plant in Florida) have worked out well for me. I've replaced all but 2 bushings on my L400. I've done all but the rear trailing arm on one side just cuz of lack of time. It's a big job replacing some of the front drive bushes.

The conclusion after 3 years is Febest bushings are cheap and good but their brake rubbers are terrible.

Febest won't sell directly but their website shows which delica buses they carry and quantity in stock.
Take care
:M :-D MD
I've been a lazy brown, green and white fox. :M Moby Dick isn't lazy anymore but what's a "Dick?" :-D

thelazygreenfox
Posts: 865
Joined: Tue Jun 08, 2010 7:21 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 99 white Hi roof gas Chamonix
Location: Coquitlam B.C.
Location: coquitlam canada

Where to get bushings? L300

Post by thelazygreenfox » Sun Nov 24, 2019 11:11 pm

In addition Febest ships in a week to the USA post office box.
MD :M :-D :-D
I've been a lazy brown, green and white fox. :M Moby Dick isn't lazy anymore but what's a "Dick?" :-D

alexhercule
Posts: 5
Joined: Fri Nov 08, 2019 5:34 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: L300 1995 P35W
Location: quebec, canada

Where to get bushings? L300

Post by alexhercule » Sat Nov 30, 2019 6:45 pm

you open it in "PREVIEW"
then go to TOOLS
then go to ADJUST SIZE
then change the WIDTH & HEIGHT from 100% to 30%
then SAVE

should work..

you can just redo it again and again and change the % until its small enough to upload on here.

Post Reply

Return to “L300 Technical”