New Battery Clamps?

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
Post Reply
msimps
Posts: 35
Joined: Wed Apr 06, 2016 7:59 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: '94 L400 "The Trail Whale"
Location: Delta

New Battery Clamps?

Post by msimps »

Finally swapped out the old (and apparently refurbished???) batteries from the Green Turtle (‘93 Super Exceed). Got some new ones through Edmonds in Burnaby (they were great). When I installed the new ones I noticed the existing clamps that attach to the battery terminals were cracked. I’ve sourced some standard ones for the front two terminals but haven’t yet found any that look like the ones attached to the rear (pic below). Had anyone sources these from somewhere or found another solution? Thanks!

[img]https://uploads.tapatalk-cdn.com/201712 ... e196e0.jpg[/img]



Sent from my iPhone using Tapatalk
Last edited by msimps on Fri Dec 22, 2017 7:31 pm, edited 3 times in total.
User avatar
lrp374
Posts: 1023
Joined: Sun Nov 23, 2008 9:56 pm
Vehicle: 91 Super Exceed
Location: Kamloops

New Battery Clamps?

Post by lrp374 »

I got a set of used ones from RMI on the Island this summer. I think I was just in the right place @ the right time for a change. You may need to make your own. If you get a piece of copper ground bar it can be done! Good luck. :-)
User avatar
Lapprentis
Posts: 357
Joined: Sat Dec 28, 2013 6:02 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica L300 StarWagon 1990
Location: Quebec

New Battery Clamps?

Post by Lapprentis »

Just type that on Ebay.ca: car battery terminal clamp 12v

Lapprentis :M
User avatar
weelsey
Posts: 73
Joined: Mon Nov 13, 2017 5:36 pm
Member's Photo Album: http://www.delica.ca/Photos/profile.php?uid=15295
Vehicle: '90 2.5l high roof exceed
Location: Harvey Parish, NB

New Battery Clamps?

Post by weelsey »

I did some scavaging from mkiv VWs for the very nice battery clamps and did some adaptation for second battery install. They are there for back-up now since I was not impressed by the outoparts terminal to wingnut set-up that came with the 'pig', and I like the built in terminal stud and cam tensioner (which can also be used for a terminal in a pinch).
Post Reply

Return to “L300 Technical”