What did you do TO your Delica today?

1994delicaman · Post by **1994delicaman** » Tue Jan 22, 2013 10:04 pm

Changed the oil today and cleaned the K&N filter and gave her a wash too

lettereleven · Post by **lettereleven** » Wed Jan 23, 2013 12:54 am

Had the tailgate cylinders refurbished. No more bruises on the back of my head!

lettereleven · Post by **lettereleven** » Wed Jan 23, 2013 10:49 pm

I broke it.

In the process of replacing link bushing and "snap"!

: ImageUploadedByTapatalk1359006553.386874.jpg (41.94 KiB) Viewed 7265 times

Damn.

Deli-East · Post by **Deli-East** » Thu Jan 24, 2013 6:22 pm

Today I registered my 1994 Delica Spacegear in Canada for the first time. It wasn't without a few obstacles but I got'er done.
Now to install new Inner Tie Rods for the safety inspection.
So, although it does not sound epic, I am still pretty happy to have it sitting legally in my driveway in January after paying for it back in early November.
Just praying it made the voyage from Japan to Halifax in one piece and then the somewhat epic journey through Canada Customs, the dockyard, Provincial Registration office and local auto shop.
Well, we made it!

Anyway, have a drink for me.

Cheers,
Jim
Planetdelica.com

Shaun Van Ramen · Post by **Shaun Van Ramen** » Fri Jan 25, 2013 6:10 pm

Deli-East wrote:Today I registered my 1994 Delica Spacegear in Canada for the first time. It wasn't without a few obstacles but I got'er done.
Now to install new Inner Tie Rods for the safety inspection.
So, although it does not sound epic, I am still pretty happy to have it sitting legally in my driveway in January after paying for it back in early November.
Just praying it made the voyage from Japan to Halifax in one piece and then the somewhat epic journey through Canada Customs, the dockyard, Provincial Registration office and local auto shop.
Well, we made it!

Anyway, have a drink for me.

Cheers,
Jim
Planetdelica.com

Very Sweet.
I know I will. And it will be a very nice brand of sake. Congrats!!!

Artacoma · Post by **Artacoma** » Sat Jan 26, 2013 9:23 am

Had a remote alarm installed , a Viper 3303 , it's upgradable and can support remote start , garage door opener etc.
Had it installed at Visions electronics in Langford.
They seemed to know whats up with JDMs and performed a clean install with the exception of one mismatched door panel screw.
Although ...........
I bought the system in December and was getting poor feedback on when the system might arrive with unreturned phone calls and emails so I went in to cancel my purchase after 5 weeks and my system magically arrived the next day and was installed the following day.

Deli-East · Post by **Deli-East** » Sat Jan 26, 2013 3:06 pm

Today I decided to build my own roof rack as there is a serious lack of Delica parts available in Atlantic Canada..
So here it is in it's first stage.
Now I need to get the uprights bent to the correct offset....

Artacoma · Post by **Artacoma** » Sun Jan 27, 2013 2:06 pm

New speakers in the door and dash
4" in the dash and 6 1/2" in the doors
About 50 minutes
Check out the old ones

Post by **FalcoColumbarius** » Mon Jan 28, 2013 12:23 am

I changed the oil and drained & filled the tranny last week. Today I changed out my fuel filter, plus I finally got around to re-installing the cross brace onto the battery pack as I have changed back to the flat top sealed batteries. Next I need to grease my nipples

.

Falco.

P.S.: Nice looking speakers, Rik ~ kinda reminds me of some old cut-off jeans I had back in the seventies. FC

Post by **nxski** » Mon Jan 28, 2013 2:05 am

FalcoColumbarius wrote:Next I need to grease my nipples

TMI!

Deli-East · Post by **Deli-East** » Mon Jan 28, 2013 6:57 pm

3 new belts today.
Ahhhh the silence:)

lettereleven · Post by **lettereleven** » Tue Jan 29, 2013 8:54 am

Repaired my sway bar links (after snapping them). Kinda sketchy driving around with no sway bar - actually it's nauseating. They should call it the anti-nausea bar instead.

Nukes25 · Post by **Nukes25** » Thu Jan 31, 2013 12:53 pm

I changed the oil today, found out how to get at the air filter ( didn't know it.was from underneath) and found out the k&n 3001 oil filter doesnt fit ( or maybe I just wasn't getting it lined up right)

1994delicaman · Post by **1994delicaman** » Mon Feb 11, 2013 11:15 am

I installed a new auto meter boost gauge because my old equus gauge crapped out!

Post by **FalcoColumbarius** » Fri Feb 15, 2013 8:02 pm

nxski wrote:
FalcoColumbarius wrote:Next I need to grease my nipples
TMI!

Well.... I greased my nipples. All eleven of them!

Then I greased the little skinny thing that sticks out between the body and the door. Boy does that door open easily now, I nearly pulled the door off the first time I opened it. No resistance at all.

Falco.

Delica Canada | Mitsubishi Van Club