Make me a bed?

Nomadic · Post by **Nomadic** » Mon Mar 23, 2009 1:04 pm

Hello,
I posted a message in the 'introduction' section just wondering if anyone could help me make a bed by April 9th? My new Delica will be home for the summer. (Victoria/Vancouver area)
Thank so much!

Erebus · Post by **Erebus** » Mon Mar 23, 2009 6:53 pm

Sorry, I haven't checked the intro section in a few days. I'm in Calgary, so can't help directly, but there's some info on the bed I made in my trip log -- http://www.delica.ca/forum/inuvik-or-bu ... 041#p23041.

TardisDeli in Richmond has also posted on their bed, with quite a few photos. http://www.delica.ca/forum/methods-of-s ... 809#p14809

electrik_jester · Post by **electrik_jester** » Mon Mar 23, 2009 9:57 pm

You looking for a quick and dirty bed or for a finished designer model with walnut finish? I can help you out talking about the former Mine was pretty cheap, read near free if you can raid the woodshed, and does the job for me. I am in Vic if you want to see and sample.

Some 3/4 inch ply, some two by six, four corner plates, a little saw action, some screws and you are in business, pops in and out easy if needs be with the removal of two screws. The expensive bit is the foam pad.

zissou · Post by **zissou** » Wed Mar 25, 2009 1:13 pm

Hey Sean... I haven't seen your set-up. I've been thinking of setting something up in my van. May be a good excuse to meet for a pint?

electrik_jester · Post by **electrik_jester** » Wed Mar 25, 2009 10:15 pm

Always up for a pint

Delica Canada | Mitsubishi Van Club

Make me a bed?

Make me a bed?

Re: Make me a bed?

Re: Make me a bed?

Re: Make me a bed?

Re: Make me a bed?