Delica Canada | Mitsubishi Van Club

Ouch..that sounds expensive, but not as expensive as a new engine.. Sorry for the late reply; I was away to Jolly ol England. I'm going to save your message and take it with me to CVI and have them fix me up.

thank you, I'll let you know what happens

Chris

My Deli has recently started to squeal when I accelerate hard. If I slowly get up to speed it doesn't happen. Is it most likely one of the belts?

Chris

My tachometer has been intermittently not working the last few days. I read that it could be the wire on thhe injector pump might have gotten loose.. I had a peek in the engine compartment, but alas. Where the eff is it?

Chris

Thanks... It was tons of fun, and I've already signed up for next year :)

Did you ride?

...And yet again, you guys saved my skin. I was thinking there was something serious wrong with the electrical. The coffee stir stick fix? Who would've thought.. Another thing that happens when the horn fuse is pulled: I got home and turned off the ignition, and the motor wouldn't stop.. :shock: Ok,...

I think the cold weather and ice did not so good things to my Deli. I parked her at a park&ride near Langford this morning at 530AM. I got picked up and drove to Comox to work and i get a phone call. "Chris, the cops just called and they say your alarm is going off in your van" . (I do...

I was up that way on Thursday.. I did see quite a few Delis in Squamish. Most wave back..

Funny.. I'm currently trying to repair my leak as well. Every screw has been a nightmare to remove. I've had to drill them all and use a screw extractor on every one so far. I thought I was at the end, but there is one left. The one under the window rubber is being a cow as well.. I soaked it in WD4...

The screw extractor works like a charm. I stuck it onto an extension and then onto a screwdriver handle. It came out like nothing. Tomorrow I will remove it all and seal up the leaks behind the panel and put it all back together. I'll have to find a few new metal screws from somewhere to replace the...

Thanks everyone! They aren't Depo lights... I'm getting a set of screw extractors that fit a screwdriver handle cause the drill won't fit in there... So, if I do upgrade to Depo lights, they will fit better and be brighter etc? The reason I'm taking these out is because one side is hanging loosely a...

Anybody else have screws that just will not come out?? I'm needing to remove my headlights on my 92 Exceed, and one of the front screws is totally messed. There's very little room in there, but I was able to get my dremel with flexible shaft to attempt to make a slot in the screw.. It was too dark, ...

So, I go and check the oil the other day.. I look at the throttle mechanism, and notice that there was a nut that came loose on the linkage.. Ok, I tighten her up, and all of the sudden my MS Bitchi wasn't Bitchi no mo'.. Wht didn't I check that out before? Going up the Malahat at a top speed of 60k...

The fluid isn't exactly pink, no... Hmm, maybe I will flush it out.. Any recommendations on brand of ATF ?

Ha..that's a little embarrassing, but brave to admit :)

Mine still ain't werkin..oh well. I'll have to take it somewhere I suppose. Any recommendations for somewhere around Victoria? Since it's not something supercritical, maybe taking it all the way to Parksville isn't necessary?

Just did that... it was a bit low for sure.. I measured with the engine running,, Hmm, what can cause that? Mebbe I should have the trannie flushed completely?