Page 1 of 1
Hello and a question about subframe bolts
Posted: Thu Apr 16, 2009 9:27 pm
by riverdude
Yo, Riverdude here hailing from Powell River. Have had my Delica for almost a year now and have been slowly been getting more into wrenching on it myself. Up until now i have been using this site from the side lines as i dont think i have much mechanical advice to offer to this site but now i must pipe up and ask for some advice on tightening the subframe bolts to deal with a front end clunk. Which bolts are they exactly? I found pic some one had posted but not shure if it is correct, are they the 4 bolts that attach to the lower control arm or am i way off ? any help would be much apreciated.
Thanks
Re: Hello and a question about subframe bolts
Posted: Thu Apr 16, 2009 10:30 pm
by FalcoColumbarius
Have you checked "Front Axle" in "Technical Downloads" in Delica Wiki?
http://wikrad.com/delica/index.cgi?serv ... _downloads
Falco.
Re: Hello and a question about subframe bolts
Posted: Mon Apr 20, 2009 4:54 pm
by nishby
Hey Riverdude. Go here:
http://www.delica.ca/forum/clunk-5025.html
There's a pic of one of the bolts you're looking for. Once you locate it, you shouldn't have trouble finding the rest.
Cheers,
Shane.
Re: Hello and a question about subframe bolts
Posted: Mon Apr 20, 2009 9:04 pm
by after oil
welcome river dude! im in powell river too, and you have lots of company up here! how bout some pictures of your delica?
Re: Hello and a question about subframe bolts
Posted: Tue Apr 21, 2009 12:37 am
by BCDelica
Hello Riverdude from another Powell Riverite (OK, ex); with your nickname I'd guessed you to be Afteroils father in-law. Guess not.
Picture attached was taken in PR;
Re: Hello and a question about subframe bolts
Posted: Wed Apr 29, 2009 8:40 pm
by riverdude
Thanx dudes got er all tight now