Page 1 of 1
Make me a bed?
Posted: Mon Mar 23, 2009 1:04 pm
by Nomadic
Hello,
I posted a message in the 'introduction' section just wondering if anyone could help me make a bed by April 9th? My new Delica will be home for the summer. (Victoria/Vancouver area)
Thank so much!
Re: Make me a bed?
Posted: Mon Mar 23, 2009 6:53 pm
by Erebus
Sorry, I haven't checked the intro section in a few days. I'm in Calgary, so can't help directly, but there's some info on the bed I made in my trip log --
http://www.delica.ca/forum/inuvik-or-bu ... 041#p23041.
TardisDeli in Richmond has also posted on their bed, with quite a few photos.
http://www.delica.ca/forum/methods-of-s ... 809#p14809
Re: Make me a bed?
Posted: Mon Mar 23, 2009 9:57 pm
by electrik_jester
You looking for a quick and dirty bed or for a finished designer model with walnut finish? I can help you out talking about the former Mine was pretty cheap, read near free if you can raid the woodshed, and does the job for me. I am in Vic if you want to see and sample.
Some 3/4 inch ply, some two by six, four corner plates, a little saw action, some screws and you are in business, pops in and out easy if needs be with the removal of two screws. The expensive bit is the foam pad.
Re: Make me a bed?
Posted: Wed Mar 25, 2009 1:13 pm
by zissou
Hey Sean... I haven't seen your set-up. I've been thinking of setting something up in my van. May be a good excuse to meet for a pint?
Re: Make me a bed?
Posted: Wed Mar 25, 2009 10:15 pm
by electrik_jester
Always up for a pint