Page 1 of 1

Rear Heat.

Posted: Fri Feb 27, 2009 9:10 pm
by Bessie the Mud Slayer
First off, I did search, and spent a half hour finding nothing much helpful.

So, rear heat stopped working. No big 'tell', it just worked one day, next day it didn't. I checked fuses, all are well. I'm getting motivated to rip the rear heat system apart; any advice? Tips?

Re: Rear Heat.

Posted: Fri Feb 27, 2009 9:58 pm
by snelson
You're sure it's not the vent selector you have set to 'roof'. Heat apparently only works when vents are set to 'floor'. Just a suggestion.
Steve

Re: Rear Heat.

Posted: Sat Feb 28, 2009 6:12 am
by Bessie the Mud Slayer
snelson wrote:You're sure it's not the vent selector you have set to 'roof'. Heat apparently only works when vents are set to 'floor'. Just a suggestion.
Steve
Yes, I'm sure.

Re: Rear Heat.

Posted: Sat Feb 28, 2009 1:41 pm
by Luna-Sea
Hey,
No fan ? Or Fan with no heat?

Cold sucks :o

A few people seem to be having issues with this lately.
Figuring it out would be..
Right on!

Re: Rear Heat.

Posted: Sat Feb 28, 2009 10:14 pm
by Bessie the Mud Slayer
Fanless...... :(

Re: Rear Heat.

Posted: Sun Mar 01, 2009 1:44 am
by Luna-Sea
Hey,
So a switch is hooped maybe or the fan is done, in you can get under there on the starboard beam (under on the driver side in the middle)
you could try feeding the fan some power with a jumper wire and see if it works, then you would know whether you have to change the fan or hunt down switches and other stuff.

Also has Bessie been slaying any mud lately?
That whole fan unit in kinda suseptable to mud and moisture so it might just be a crap connection somewhere. Clean up any ones you can reach.
Also really look close at your fuses they are not always all black and toasty when there are done.
(I know you said you checked already)

Good luck and right on 8-)

Re: Rear Heat.

Posted: Sun Mar 08, 2009 10:10 pm
by Bessie the Mud Slayer
Well I finally got under her and checked the fan. No power at fan, but power at fuses......
I guess I start tracing it back and find the weak link.