Page 1 of 1

New Battery Clamps?

Posted: Fri Dec 22, 2017 7:31 pm
by msimps
Finally swapped out the old (and apparently refurbished???) batteries from the Green Turtle (‘93 Super Exceed). Got some new ones through Edmonds in Burnaby (they were great). When I installed the new ones I noticed the existing clamps that attach to the battery terminals were cracked. I’ve sourced some standard ones for the front two terminals but haven’t yet found any that look like the ones attached to the rear (pic below). Had anyone sources these from somewhere or found another solution? Thanks!

[img]https://uploads.tapatalk-cdn.com/201712 ... e196e0.jpg[/img]



Sent from my iPhone using Tapatalk

New Battery Clamps?

Posted: Tue Dec 26, 2017 10:01 am
by lrp374
I got a set of used ones from RMI on the Island this summer. I think I was just in the right place @ the right time for a change. You may need to make your own. If you get a piece of copper ground bar it can be done! Good luck. :-)

New Battery Clamps?

Posted: Tue Dec 26, 2017 12:03 pm
by Lapprentis
Just type that on Ebay.ca: car battery terminal clamp 12v

Lapprentis :M

New Battery Clamps?

Posted: Thu Dec 28, 2017 1:09 pm
by weelsey
I did some scavaging from mkiv VWs for the very nice battery clamps and did some adaptation for second battery install. They are there for back-up now since I was not impressed by the outoparts terminal to wingnut set-up that came with the 'pig', and I like the built in terminal stud and cam tensioner (which can also be used for a terminal in a pinch).