Delica Canada | Mitsubishi Van Club

Hi all, just wanted to say what great and efficient service I had with Muffler-tech on the forum advice of getting exhaust work done. http://www.muffler-tech.com/

I called up Ryan yesterday morning asking about getting some work done, drove down, explained what I wanted. They have done Delicas before, so they're on board with it all, they gave me some suggestions, and I had everything dropped off by 11am and back to me by 4pm.

I got the use of their courtesy vehicle for the day, and the job came in an hour under the quoted price.

What more can I say? Unfortunately I didn't snap off any photos, but others have gone there and gotten the 2.5" diameter exhaust done as well... The photos are on delica.ca somewhere...

Thanks again to Ryan and crew!!

I watched Ryan work a few weeks ago on a cruiser. You pay a premium and get premium work. Drooling over the machinery when I visited.

Agreed... To even just have a lift handy!!

alti2d wrote:Hi all, just wanted to say what great and efficient service I had with Muffler-tech on the forum advice of getting exhaust work done. http://www.muffler-tech.com/

I called up Ryan yesterday morning asking about getting some work done, drove down, explained what I wanted. They have done Delicas before, so they're on board with it all, they gave me some suggestions, and I had everything dropped off by 11am and back to me by 4pm.

I got the use of their courtesy vehicle for the day, and the job came in an hour under the quoted price.

What more can I say? Unfortunately I didn't snap off any photos, but others have gone there and gotten the 2.5" diameter exhaust done as well... The photos are on delica.ca somewhere...

Thanks again to Ryan and crew!!

Yes he installed my pyrometer sensor a few months back. Very personable and efficient, nice to have a person who can weld S/S.

just out of interest's sake, what is a ballpark figure for your stainless steel exhaust system and installation?

Also what muffler did you go for?