Page 2 of 2

Re: Is there another L400 in Calgary?

Posted: Sun Sep 27, 2009 8:35 pm
by Pacific JDM Parts
Clunking in the rear on L400's going over bumps is normally excess play in the rear sway bar links and rear sway bar bushes.Just grab the rear sway bar and see if there is any movement up and down on both sides.
Hope this helps to put an end to you going crazy!!!!

Re: Is there another L400 in Calgary?

Posted: Thu Oct 01, 2009 8:39 pm
by aclarker
Hope not. The Clunk started to happen post Pro Active... Maybe, I'll get up on a hoist and take a look.

Re: Is there another L400 in Calgary?

Posted: Tue Oct 20, 2009 7:22 pm
by madmazda
well i live in calgary and am going to be a new owner of a delica spacegear really soon...... I'm hoping I can find a block heater.... hopefully an in line one will do the trick

Re: Is there another L400 in Calgary?

Posted: Wed Nov 11, 2009 8:30 pm
by Erebus
madmazda wrote:well i live in calgary and am going to be a new owner of a delica spacegear really soon...... I'm hoping I can find a block heater.... hopefully an in line one will do the trick
In-line heaters suck compared to block heaters. Don't bother with an in-line, waste of money. Block heater is the way to go.

Re: Is there another L400 in Calgary?

Posted: Wed Nov 11, 2009 9:01 pm
by Green1
talk to mardy, he's now done a block heater on my new L400, so I'm sure he can give you pointers on how to install one...

Re: Is there another L400 in Calgary?

Posted: Wed Nov 11, 2009 9:25 pm
by DelicaFreaka
madmazda wrote:well i live in calgary and am going to be a new owner of a delica spacegear really soon...... I'm hoping I can find a block heater.... hopefully an in line one will do the trick
Here, check this out. It is a fairly simple install if you know your way around some simple tools. I will be doing mine shortly. Just remember that after you drain the rad and pull the line off the rear heater unit you will still have some coolant gush from the right rear frost plug when you bang it out. Put a tarp down to catch or stuff some towels under the plug to soak most of it up as it comes out. A little tight to get at but definitely can be done. No lifting of the vehicle required. Good luck...........................Kirk out.

****Block Heater Part # (found at Lordco) 3100049..... $35.00 ****

http://www.delica.ca/forum/block-heater ... -6592.html