Rim Compatibility

P.Gaudreault · Post by **P.Gaudreault** » Thu Jul 16, 2015 7:28 pm

There is a shop here who he charge 75$$ pers wheel for machining a guy told me. 300$$ for 4. Aaaouchhh!!

Thank you

P.Gaudreault · Post by **P.Gaudreault** » Fri Jul 24, 2015 8:19 am

33 mm is the offset of our van and 6'' width. I found this info on the web. Do you have the same??

http://www.wheel-size.com/size/mitsubishi/delica/

If I buy rims with 0mm offset and 8'' width, it will looks good.

Croftcastles · Post by **Croftcastles** » Tue Dec 15, 2015 12:57 pm

Did you end up getting these offset rims?

Any idea if you kept the 33mm offset and went 8" wide, would your tires rub with the wheel cranked?

Post by **Big-Bird** » Thu Dec 17, 2015 5:45 am

Alberta Wheel Repair in Calgary charged me $40 per loose rim to CNC the center hole on my Toyota Steel rims. 15x8 with a .5" wider offset than stock so they give a wide stance.

Stuffed a set of 31x10.50x15 arctic claws on them...great winter combo.

Post by **thelazygreenfox** » Thu Dec 17, 2015 9:00 am

Croftcastles
The answer is yes! One time I had a BFG AT KO and compared it to a Michelin of the same size 15x 9.50. The only difference was in the (1/2") width of the tire tread.

When cranked the BFGs hit and the Michelins didn't. Go figure but needless to say I bought the Michelins.
TLGF

Croftcastles · Post by **Croftcastles** » Thu Dec 17, 2015 3:28 pm

Thanks Gents!

TLGF - I'm assuming you're running wider than stock rims? Also assuming the size of these Michelin's would be 30"?

Delica Canada | Mitsubishi Van Club

Rim Compatibility

Re: Rim Compatibility

Re: Rim Compatibility

Re: Rim Compatibility

Re: Rim Compatibility

Re: Rim Compatibility

Re: Rim Compatibility