Inclinometer Pod

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
Post Reply
Lordsxo
Posts: 12
Joined: Sat Oct 07, 2017 7:00 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica Star Wagon Active World '97
Location: Toronto

Inclinometer Pod

Post by Lordsxo »

More of an experience than anything else. So I was driving my 97 Active World, it was a bit of a rough gravel road, and I hit a deep pot hole. When I did the Inclinometer Pod removed itself from the dash, making a sound of shattering plastic. The parts around the screw are still attached but broken from the Pod.

I'm going to try and collect all the pieces and JB weld them together again, but has anyone else experienced this? BTW, nothing else noticeably wrong.
kastles
Posts: 3
Joined: Thu Jul 05, 2018 5:32 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Vera, a 1999 Chamonix
Location: London, ON

Re: Inclinometer Pod

Post by kastles »

Good luck with the JB job. My next small project to tacke is fixing my incimeter ball.
coop74
Posts: 3
Joined: Fri Jun 26, 2020 8:36 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 92 L300 Delica
Location: ALCOA

Re: Inclinometer Pod

Post by coop74 »

put your pcs together and get it scanned and see if someone can 3d print you one... then find someone who does plastic welding. Likely however it busted because of age and it will not work but just break again... sorry
Post Reply

Return to “L300 Technical”