How to dismantle sliding windows?

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
Post Reply
STL
Posts: 64
Joined: Thu Jun 11, 2009 4:06 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: L300 4wd

How to dismantle sliding windows?

Post by STL » Sat Oct 05, 2019 9:17 am

Hi all,

I found a Hyundai H100 sliding door here in France and it has a sliding window (I have fixed glass window). The windows look like the one from the Mitsu.

They need some work to look clean again but I struggle on how to approach the restoration ... :-) How to get the two glasses out? Just remove the run channel gasket and try to get the glass out but how? It seems that there is a sort of frame that if removed could make the whole work a lot easier.
L300-sliding-window.png
L300-sliding-window.png (84.72 KiB) Viewed 114 times
Did anyone try this ? Any suggestion?

Thanks!

STL

User avatar
Growlerbearnz
Posts: 2021
Joined: Sat Jun 26, 2010 1:58 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica P25W
Location: New Zealand

How to dismantle sliding windows?

Post by Growlerbearnz » Sat Oct 05, 2019 8:32 pm

I posted about this over on DelicaForum just the other day! http://delicaforum.com/index.php?thread ... ment.1478/
Nothing says "poor workmanship" more than wrinkles in the duct tape.

STL
Posts: 64
Joined: Thu Jun 11, 2009 4:06 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: L300 4wd

How to dismantle sliding windows?

Post by STL » Sun Oct 06, 2019 3:40 am

Ok cool! Many thanks!

It seems that the trick is to pull up the frame to get the glasses out. Didn't think about this one!!! :-)

I'll get back here if I am stuck.

A picture for your great help (remember when you were at primary school 8-) ), somewhere in Portugal this summer:
Somewhere-in-Portugal.jpg
Somewhere-in-Portugal.jpg (90.6 KiB) Viewed 95 times

STL
Posts: 64
Joined: Thu Jun 11, 2009 4:06 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: L300 4wd

How to dismantle sliding windows?

Post by STL » Sun Oct 06, 2019 6:25 am

OK, done. It worked fine. Next, I have to remove the tinting film on the windows -- looks like it would take some time as it is quite old.

Thx again.

Post Reply

Return to “L300 Technical”