Page 1 of 1
Dual Swing Gate
Posted: Fri Feb 01, 2013 1:14 pm
by pham
I'm looking at getting a tire carrier dual swing out fabricated for my L400. Does anyone on the forum know of anyone that fabricates them?
Thanking you ahead of time.
Paul
Re: Dual Swing Gate
Posted: Fri Feb 01, 2013 2:33 pm
by del400
I've been looking to do this as well and i will go in with you if you find a place to do it/fabricate it.
Thanks
Alex
Re: Dual Swing Gate
Posted: Fri Feb 01, 2013 3:35 pm
by pham
Alex,
I stopped in at E&H Hitch Shop Ltd in Burnaby and they have no problem in doing it.
Please send me a pm with your contact number and we'll talk over the phone.
Regards,
Paul
Re: Dual Swing Gate
Posted: Fri Feb 01, 2013 4:41 pm
by mararmeisto
pham wrote:...E&H Hitch Shop Ltd in Burnaby and they have no problem in doing it...
Finally, a reputable shop to undertake this type of project. It'll be good to see the results - looking forward to images.
Re: Dual Swing Gate
Posted: Fri Feb 01, 2013 5:14 pm
by psilosin
If the end result is as good looking and useful as some of the AU designs I'd likely get one as well...but not commiting to anything since the rig is up for sale at the moment.
Re: Dual Swing Gate
Posted: Sat Feb 02, 2013 7:17 pm
by del400
PM Sent
Re: Dual Swing Gate
Posted: Sat Feb 02, 2013 10:42 pm
by thedjjack
maybe I am just to lazy but a dual swing seems like too much work to open the back door...
I have a single side swing and it seems like a lot of work to open the back hatch....I would not want to swing two just to get in the back....