Anyone have any recommendations for ECM repair in Calgary? Some of the components on the board need to be replaced and a tracing needs to be resoldered.
Phil
ECM REPAIR
-
skippyalbright
- Posts: 10
- Joined: Wed Feb 06, 2008 10:56 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1992 Exceed
-
marsgal42
- Posts: 772
- Joined: Fri Jul 20, 2007 3:05 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: The Mighty Gumdrop
- Location: Burnaby, B.C.
Re: ECM REPAIR
If you mean the glow plug controller, anybody who knows which end of a soldering iron to pick up can fix it.
...laura
...laura
-
Erebus
- Posts: 1369
- Joined: Mon May 28, 2007 7:55 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1992 Super Exceed
- Location: Edmonton, Alberta
- Location: Edmonton (was Calgary until 2017), Alberta, Canada
- Contact:
Re: ECM REPAIR
I'm not bad with a soldering iron, but I don't go near circuit boards. Green1's a lot better at than I.marsgal42 wrote:If you mean the glow plug controller, anybody who knows which end of a soldering iron to pick up can fix it.
"I could be just around the corner from heaven, or a mile from hell." -- Jackson Browne, "The road and the sky".