Good day,
I installed a 2'' lift kit on my Deli couple month ago and since then my 4X4 is not working anymore. When I try to engage my 4X4 nothing happen, just a small noise.. Before I installed my lift I had no problem with my 4X4 and I did nothing hard on the mechanic since I installed my kit.
4X4 is not working..
-
- Posts: 116
- Joined: Thu Sep 18, 2014 8:57 am
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Mitsubishi Delica 1998 Chamonix
- Location: Cherry Grove, Ab
-
- Posts: 29
- Joined: Mon Aug 21, 2017 8:06 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: L400
- Location: winnipeg
4X4 is not working..
any resolution to your problem? I also installed a 2" lift and now I'm getting the dreaded flashing front wheels on the dash. I also installed a new radio that apparently could have caused a poor connection to a module. IDK... and it's too cold right now to trouble shoot lol... :(
-
- Posts: 116
- Joined: Thu Sep 18, 2014 8:57 am
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Mitsubishi Delica 1998 Chamonix
- Location: Cherry Grove, Ab
4X4 is not working..
Yes probleme resolved. My probleme was, last year I ordered an used CV axle and installed this axle at the same time then my lift kit. When I installed this used CV axle I didn't see that this axle was messed up. There was 28 slines outboard and 25 slipes inboard. Then when I tried to drive on 4X4 the axle just pop out and have been ginded by the diff. I have been Lucky that the front diff didn't get any damage. I ordered a brand new CV axle from Austrlia 28 splines in and out and everything is working find.