Trying to Remove Washer Jets

Mitsubishi Delica L400 production commenced in 1994 -- After much anticipation, the L400 arrived on Canadian Soil in 2009!
pj_jazzy_janz
Posts: 93
Joined: Wed May 21, 2014 7:28 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: '94 L400 LWB
Location: Winnipeg, MB

Trying to Remove Washer Jets

Postby pj_jazzy_janz » Thu Apr 13, 2017 11:14 am

Went poking around in there the other day (trying to angle the driver side a bit higher), but can't seem to get at the underside of the jets. Does anyone know the trick?

Ralph in Winnipeg
Posts: 74
Joined: Wed Sep 02, 2015 7:42 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 94 Strada
Location: Winnipeg

Trying to Remove Washer Jets

Postby Ralph in Winnipeg » Wed Apr 19, 2017 4:32 am

I'm pretty sure that you can angle the jets without removing them. I usually use a push pin (like on a bulletin board) and stick it it the nozzle to move it around. Ralph in Winnipeg.

pj_jazzy_janz
Posts: 93
Joined: Wed May 21, 2014 7:28 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: '94 L400 LWB
Location: Winnipeg, MB

Trying to Remove Washer Jets

Postby pj_jazzy_janz » Wed Apr 19, 2017 6:50 am

I'd heard that. I tried to jiggle some kind of pin in there, but it clearly lacked the required fortitude and broke off in the nozzle. :shock: Much cursing ensued. Now I need to get it out. I just can't figure out how to get at the underside of the jet.


Return to “L400 Technical”

Who is online

Users browsing this forum: No registered users and 1 guest