Front blower resistors for fan speed
Posted: Wed Apr 13, 2016 10:43 am
The previous owner bypassed the blower resistor pack and I would like to get my fan speeds back. The resistor pack is below/behind the glove box. It is a black 3cmx10cm rectangle held in by two screws. There is a single electrical clip with 4 wires coming out of it. I need to know what wire goes where as the previous owner cut the clip off and bypassed it. My wire colours are 2 thick black and 2 thin blue. One of each with a stripe.
This favour should not require any dis-assembly of the van. Just look below your glove box and snap a pic of the wire colours.
If someone wants to be extra helpful could you check the resistance between the pins on the resistor bank itself?
Thanks in advance.
This favour should not require any dis-assembly of the van. Just look below your glove box and snap a pic of the wire colours.
If someone wants to be extra helpful could you check the resistance between the pins on the resistor bank itself?
Thanks in advance.