Delica Canada | Mitsubishi Van Club

In need of a complete rear passengers seat belt.

I have a 91 super exceed that I am no longer using the rear bench. If it’s the same we could work something lit.

Dave

Is your middle row Captains chairs or bench seat? Do you need middle row or rear row? 3-point belts or lap belts? Retractable or static? (Yes, it sounds like I'm being an ass, but I've just gone through this with my own van- there's a ridiculous range of seatbelt configurations out there).

If you get desperate, I've ordered belts from https://www.seatbeltplanet.com/ before, and they're great.

Growlerbearnz wrote:Is your middle row Captains chairs or bench seat? Do you need middle row or rear row? 3-point belts or lap belts? Retractable or static? (Yes, it sounds like I'm being an ass, but I've just gone through this with my own van- there's a ridiculous range of seatbelt configurations out there).

If you get desperate, I've ordered belts from https://www.seatbeltplanet.com/ before, and they're great.

Growler, do you remember which ones you ordered? I missing the driver's side retractable shoulder/lap belt for the middle row, and have been keeping an eye out but haven't found a replacement.

I looked at the site, and it seems like the generic ones (this one: https://www.seatbeltplanet.com/seatbelt ... 25/view/59) might work fine. Is that what you've done?

Thanks!

I have 140" end release buckle with the 8" sleeve (https://www.seatbeltplanet.com/seatbelt ... 25/view/61), ready to install on my captains chairs (buckle attached to the chair where the original retractible lap belt went, retractor and lower mount in the C-pillar, shoulder loop on the C-pillar).

I haven't actually installed them yet, but they should work fine.

Growlerbearnz wrote:I have 140" end release buckle with the 8" sleeve (https://www.seatbeltplanet.com/seatbelt ... 25/view/61), ready to install on my captains chairs (buckle attached to the chair where the original retractible lap belt went, retractor and lower mount in the C-pillar, shoulder loop on the C-pillar).

I haven't actually installed them yet, but they should work fine.

Those look perfect. Thanks very much!

Growlerbearnz wrote:I have 140" end release buckle with the 8" sleeve (https://www.seatbeltplanet.com/seatbelt ... 25/view/61), ready to install on my captains chairs (buckle attached to the chair where the original retractible lap belt went, retractor and lower mount in the C-pillar, shoulder loop on the C-pillar).

I haven't actually installed them yet, but they should work fine.

Hey @Growlerbearnz, did you end up installing this? I’m needing both driver and passenger front seat replacements. Wondering which part number to order from seatbeltplanet

I did, but that's on the rear captains chairs. The front seat belts are shorter- you're just going to have to measure them