Rear passengers seat belt (92 l300)

Looking for a specific hard-to-find Delica part? Post your request in this section. Commercial postings can be found in "Delica Trader Parts Section".

Moderators: delicanuck, mark

Post Reply
Zebruken
Posts: 10
Joined: Mon Apr 17, 2017 9:44 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: n/a
Location: Washington State

Rear passengers seat belt (92 l300)

Post by Zebruken »

In need of a complete rear passengers seat belt.
Dhelgren
Posts: 7
Joined: Sun Jun 04, 2017 5:39 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1991 L300 super exceed
Location: Wisconsin

Rear passengers seat belt (92 l300)

Post by Dhelgren »

I have a 91 super exceed that I am no longer using the rear bench. If it’s the same we could work something lit.

Dave
User avatar
Growlerbearnz
Posts: 2041
Joined: Sat Jun 26, 2010 1:58 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica P25W
Location: New Zealand

Rear passengers seat belt (92 l300)

Post by Growlerbearnz »

Is your middle row Captains chairs or bench seat? Do you need middle row or rear row? 3-point belts or lap belts? Retractable or static? (Yes, it sounds like I'm being an ass, but I've just gone through this with my own van- there's a ridiculous range of seatbelt configurations out there).

If you get desperate, I've ordered belts from https://www.seatbeltplanet.com/ before, and they're great.
Nothing says "poor workmanship" more than wrinkles in the duct tape.
User avatar
phalteman
Posts: 23
Joined: Sun Mar 05, 2017 1:59 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1994 L300/Starwagon P25W
Location: Vancouver

Rear passengers seat belt (92 l300)

Post by phalteman »

Growlerbearnz wrote:Is your middle row Captains chairs or bench seat? Do you need middle row or rear row? 3-point belts or lap belts? Retractable or static? (Yes, it sounds like I'm being an ass, but I've just gone through this with my own van- there's a ridiculous range of seatbelt configurations out there).

If you get desperate, I've ordered belts from https://www.seatbeltplanet.com/ before, and they're great.
Growler, do you remember which ones you ordered? I missing the driver's side retractable shoulder/lap belt for the middle row, and have been keeping an eye out but haven't found a replacement.

I looked at the site, and it seems like the generic ones (this one: https://www.seatbeltplanet.com/seatbelt ... 25/view/59) might work fine. Is that what you've done?

Thanks!
User avatar
Growlerbearnz
Posts: 2041
Joined: Sat Jun 26, 2010 1:58 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica P25W
Location: New Zealand

Rear passengers seat belt (92 l300)

Post by Growlerbearnz »

I have 140" end release buckle with the 8" sleeve (https://www.seatbeltplanet.com/seatbelt ... 25/view/61), ready to install on my captains chairs (buckle attached to the chair where the original retractible lap belt went, retractor and lower mount in the C-pillar, shoulder loop on the C-pillar).

I haven't actually installed them yet, but they should work fine.
Nothing says "poor workmanship" more than wrinkles in the duct tape.
User avatar
phalteman
Posts: 23
Joined: Sun Mar 05, 2017 1:59 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1994 L300/Starwagon P25W
Location: Vancouver

Rear passengers seat belt (92 l300)

Post by phalteman »

Growlerbearnz wrote:I have 140" end release buckle with the 8" sleeve (https://www.seatbeltplanet.com/seatbelt ... 25/view/61), ready to install on my captains chairs (buckle attached to the chair where the original retractible lap belt went, retractor and lower mount in the C-pillar, shoulder loop on the C-pillar).

I haven't actually installed them yet, but they should work fine.
Those look perfect. Thanks very much!
bigsleep55
Posts: 13
Joined: Fri Jul 20, 2018 5:50 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: '92 L300 2.5TD
Location: Vancouver

Rear passengers seat belt (92 l300)

Post by bigsleep55 »

Growlerbearnz wrote:I have 140" end release buckle with the 8" sleeve (https://www.seatbeltplanet.com/seatbelt ... 25/view/61), ready to install on my captains chairs (buckle attached to the chair where the original retractible lap belt went, retractor and lower mount in the C-pillar, shoulder loop on the C-pillar).

I haven't actually installed them yet, but they should work fine.
Hey @Growlerbearnz, did you end up installing this? I’m needing both driver and passenger front seat replacements. Wondering which part number to order from seatbeltplanet
User avatar
Growlerbearnz
Posts: 2041
Joined: Sat Jun 26, 2010 1:58 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica P25W
Location: New Zealand

Rear passengers seat belt (92 l300)

Post by Growlerbearnz »

I did, but that's on the rear captains chairs. The front seat belts are shorter- you're just going to have to measure them :-)
Nothing says "poor workmanship" more than wrinkles in the duct tape.
Post Reply

Return to “Parts Wanted (Non-Commercial)”