Transfer case cables...?

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
Post Reply
User avatar
ChuckBlack
Posts: 333
Joined: Tue Mar 17, 2015 9:27 pm
Member's Photo Album: http://www.delica.ca/Photos/Bingo
Vehicle: L300 Jasper
Location: St. Albert AB

Transfer case cables...?

Post by ChuckBlack » Sun Nov 25, 2018 10:06 am

Just curious if anyone else out there has the transfer case cable colour coated? Just replaced my rear crank seal this weekend and as I was installing the cable back I realized mine are colour coated. Red for the top and yellow for the bottom cable.
L300 Jasper, :-D
L300 Chamonix, :-)
Pajero Mini, :-(
Pajero GDI :o
Pajero DiD 8-)

sk66
Posts: 178
Joined: Thu Oct 06, 2016 3:24 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: '91 Delica L300
Location: Pennsylvania, USA

Transfer case cables...?

Post by sk66 » Mon Nov 26, 2018 2:16 pm

I would have to clean off a bunch of gunk to be able to tell....
Steven
1991 L300
Harrisburg, PA

User avatar
Growlerbearnz
Posts: 2026
Joined: Sat Jun 26, 2010 1:58 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica P25W
Location: New Zealand

Transfer case cables...?

Post by Growlerbearnz » Mon Nov 26, 2018 3:12 pm

Mine had rings of red and yellow tape under all the grease, it didn't actually occur to me that it was some kind of colour coding, but it would make sense on the production line. The cables are quite similar when dangling down.
Nothing says "poor workmanship" more than wrinkles in the duct tape.

Post Reply

Return to “L300 Technical”