New Front Windshield Gasket, Where To Buy

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
philmeup1
Posts: 416
Joined: Wed Aug 22, 2012 6:20 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1992 Delica
Location: Ontario

New Front Windshield Gasket, Where To Buy

Postby philmeup1 » Tue Sep 18, 2018 7:03 pm

Hello folks,

I've been working on my '93 L300 Super Exeed over the last few days trying to stay ahead of the maintenance often required on older vehicles. I have the wet floor syndrome and decided to tackle that job next. I'm going to remove the front corner panels and reseal the seam in behind these panels. And since I have a few pits in my windshield, I've decided to remove and replace it at the same time. This presumably will make removing the corner panels much easier from what I've read on here.

I live in Ontario and have sourced a windshield. But I'm having difficulty sourcing the rubber gasket that will also need replacing.

Anyone have any leads as to where I might purchase one?

Thanks in advance:)

Phil

User avatar
Growlerbearnz
Posts: 1885
Joined: Sat Jun 26, 2010 1:58 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica P25W
Location: New Zealand

New Front Windshield Gasket, Where To Buy

Postby Growlerbearnz » Tue Sep 18, 2018 7:12 pm

The part number you need is MB416390, and it's available from Amayama.com for CAD$140, if you have time to wait for shipping.
Nothing says "poor workmanship" more than wrinkles in the duct tape.

philmeup1
Posts: 416
Joined: Wed Aug 22, 2012 6:20 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1992 Delica
Location: Ontario

New Front Windshield Gasket, Where To Buy

Postby philmeup1 » Mon Sep 24, 2018 9:09 am

Ahh, thanks growlerbearnz. I ordered a combination switch from them. Very expensive but still much cheaper than anywhere else. I was hoping to find something here in Ontario, or somewhere in Canada at least.

I guess I'd better get on ordering this sooner than later. Winter is definitely on its way:(

Anyway, thanks for the help:)

Cheers, Phil


Return to “L300 Technical”

Who is online

Users browsing this forum: Growlerbearnz and 16 guests