Fuel gauge, temp gauge, tach, signals, not working. SOLVED: Short in reverse switch.
- after oil
- Posts: 1436
- Joined: Mon Feb 11, 2008 7:01 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 cham-reimo poptop L300. 78MB240D
- Location: on the road
- Location: occupied coast salish territory aka powell river
Fuel gauge, temp gauge, tach, signals, not working
I took out the switch. the wires are sketchy as ^&%$#@. They're about to break off.
- after oil
- Posts: 1436
- Joined: Mon Feb 11, 2008 7:01 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 cham-reimo poptop L300. 78MB240D
- Location: on the road
- Location: occupied coast salish territory aka powell river
Fuel gauge, temp gauge, tach, signals, not working
But wait! I tested for continuity again and there is continuity between the blue red wire and ground with and without the lapse connected so therefore I have to find the ground a short between the bullet connecters and the rear lamps
- after oil
- Posts: 1436
- Joined: Mon Feb 11, 2008 7:01 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 cham-reimo poptop L300. 78MB240D
- Location: on the road
- Location: occupied coast salish territory aka powell river
Fuel gauge, temp gauge, tach, signals, not working
Well the wires are now broken off the reverse switch so I put it back in and will order new reverse switch. The wiring harness seems clean all the way through so I don't know where that short is. So we have to figure out another time
- after oil
- Posts: 1436
- Joined: Mon Feb 11, 2008 7:01 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 cham-reimo poptop L300. 78MB240D
- Location: on the road
- Location: occupied coast salish territory aka powell river
Fuel gauge, temp gauge, tach, signals, not working
PROBLEM SOLVED Installed new reverse switch. Everything works, doesn't short when I shift in to reverse.
- Growlerbearnz
- Posts: 2041
- Joined: Sat Jun 26, 2010 1:58 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Delica P25W
- Location: New Zealand
Fuel gauge, temp gauge, tach, signals, not working. SOLVED: Short in reverse switch.
Win! Sorry I didn't help more with the frustrating diagnosis bit- I was on vacation.
Nothing says "poor workmanship" more than wrinkles in the duct tape.
- after oil
- Posts: 1436
- Joined: Mon Feb 11, 2008 7:01 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 cham-reimo poptop L300. 78MB240D
- Location: on the road
- Location: occupied coast salish territory aka powell river
Fuel gauge, temp gauge, tach, signals, not working. SOLVED: Short in reverse switch.
No worries Growlerbearnz, your help was illuminating.