engine cut out at 2xxx RPMs?

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
sk66
Posts: 155
Joined: Thu Oct 06, 2016 3:24 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: '91 Delica L300
Location: Pennsylvania, USA

engine cut out at 2xxx RPMs?

Postby sk66 » Tue Oct 16, 2018 8:52 am

pluckmyeyeout wrote:
sk66 wrote:I didn't go back through the previous history, but what about a fuel restriction... the little hidden filter screen at the injection pump?



Where is that screen? How would one check it/clean it/clear it?

It's at/inside the banjo bolt where the fuel line connects to the IP... I would just push some cleaner/compressed air through it to make sure it's clear.
Last edited by sk66 on Wed Oct 17, 2018 8:27 am, edited 1 time in total.
Steven
1991 L300
Harrisburg, PA

User avatar
Growlerbearnz
Posts: 1929
Joined: Sat Jun 26, 2010 1:58 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica P25W
Location: New Zealand

engine cut out at 2xxx RPMs?

Postby Growlerbearnz » Tue Oct 16, 2018 1:39 pm

Screen location and removal in this thread: http://www.delica.ca/forum/viewtopic.php?f=91&t=19094&start=45
Nothing says "poor workmanship" more than wrinkles in the duct tape.


Return to “L300 Technical”

Who is online

Users browsing this forum: No registered users and 13 guests