It's at/inside the banjo bolt where the fuel line connects to the IP... I would just push some cleaner/compressed air through it to make sure it's clear.pluckmyeyeout wrote:sk66 wrote:I didn't go back through the previous history, but what about a fuel restriction... the little hidden filter screen at the injection pump?
Where is that screen? How would one check it/clean it/clear it?
engine cut out at 2xxx RPMs?
-
- Posts: 189
- Joined: Thu Oct 06, 2016 3:24 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: '91 Delica L300
- Location: Pennsylvania, USA
engine cut out at 2xxx RPMs?
Last edited by sk66 on Wed Oct 17, 2018 8:27 am, edited 1 time in total.
Steven
1991 L300
Harrisburg, PA
1991 L300
Harrisburg, PA
- Growlerbearnz
- Posts: 2041
- Joined: Sat Jun 26, 2010 1:58 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Delica P25W
- Location: New Zealand
engine cut out at 2xxx RPMs?
Screen location and removal in this thread: http://www.delica.ca/forum/viewtopic.ph ... 4&start=45
Nothing says "poor workmanship" more than wrinkles in the duct tape.