How to fix your dash temp guage for good!

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
Trinker
Posts: 81
Joined: Fri Apr 17, 2015 8:37 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: L300
Location: Revelstoke

How to fix your dash temp guage for good!

Postby Trinker » Thu Nov 09, 2017 3:10 pm

There always been a lot of talk about where that little needle should sit on our dash temp gauges. I'm sure at this point a fair few people have gone ahead and needlessly changed thermostats thinking their engine was running cold. I'm also confident people have driven around with cracked heads or other cooling (heating?) issues completely oblivious because the temperature gauge never came close to the red. Well I've come up with a solution to all this madness!

You will need:

    A pair of scissors
    A roll of red electrical tape
    And one beer (I prefer craft because I save so much money doing my own repairs)

IMG_20171109_133938556.jpg
IMG_20171109_133938556.jpg (81.67 KiB) Viewed 53 times


Now just take a thin strip of red electrical tape and go ahead and extend that little red zone down, waaay down to where it belongs. On mine I've had an infared heat gun on it enough to know roughly where I should start being concerned about the temperature.

IMG_20171109_133815930.jpg
IMG_20171109_133815930.jpg (77.15 KiB) Viewed 53 times


Now go enjoy your beer, and if anyone else is driving your van (you shouldn't let anyone besides yourself drive the Delica, but sometimes it happens....) they should at least know if it's getting too hot. You will hopefully have an Exhaust Gas Temperature gauge as well, and remember every dash temperature gauge will read a bit different!
92'L300 Chamonix - Fully camperized adventure rig 8-)

Return to “L300 Technical”

Who is online

Users browsing this forum: No registered users and 3 guests