EGR blanking plates - DRAWINGS

Locked
User avatar
FalcoColumbarius
Site Admin
Posts: 5979
Joined: Tue Jan 22, 2008 1:55 pm
Member's Photo Album: http://www.delica.ca/Photos/index.php?cat=11103
Vehicle: Delica; Chamonix GLX ('92 P25W)
Location: North Van, BC, eh?

EGR blanking plates - DRAWINGS

Post by FalcoColumbarius » Mon May 23, 2016 9:14 pm

Image Original post by Tojo: http://www.delica.ca/forum/viewtopic.php?f=6&t=16881

EGR blanking plates for the L300 or L400.

Recommend 0.25 inch steel plate. You can fabricate these yourselves quite cheaply by heading down to the metal supermarket and buying some mild plate steel, hardened steel not necessary. Use an angle grinder and some drills. Print the PDF of your choice, either metric or imperial. Remember to set the "Page scaling" to "NONE" in Adobe Acrobat. Un-click the checkbox "Choose paper source by PDF page size".

Check the scale by measuring the square in the upper left corner with your calipers. Cut out the template with scissors and spray glue it onto the steel plate. Mark the outline and holes with a sharpee pen. Cut out the shapes then install. I sealed mine with high heat silicone and OE gaskets. Good luck.

Image

Image
Sent from my smart pad, using a pen.

Seek Beauty... Image Good Ship Miss Lil' Bitchi

...... Vision without action is a daydream. Action without vision is a nightmare. ~ Japanese Proverb

Locked

Return to “Accessories, Modifications & Ideas”