Front skid plates for sale, interested?

Mitsubishi Delica Camper vans, lift kits & other Delica Accessories!

Moderator: BCDelica

jesseydearing
Posts: 6
Joined: Fri Jul 21, 2017 9:36 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1991 L300 P35W Super Exceed
Location: Seattle
Location: Seattle, Washington

Front skid plates for sale, interested?

Postby jesseydearing » Thu Feb 15, 2018 12:09 am

Hey Mr. Sa,

Just checking in again to see if you were ever able to make those skid plates?

Cheers,

Jessey
1991 L300 P35W Super Exceed

User avatar
Crankshaft Culture
Posts: 84
Joined: Tue Jun 20, 2017 11:07 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1989 Delica
Location: Portland, OR
Contact:

Front skid plates for sale, interested?

Postby Crankshaft Culture » Sun Apr 22, 2018 3:56 pm

I bought one of these but cannot for the life of me figure out where it bolts up. I have an '89 L300 and have removed the two thin front guards from beneath my van. Does anyone have photos of one of these installed?

VE7LHM
Posts: 2
Joined: Sun Apr 07, 2013 9:59 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: L300
Location: Delta BC

Front skid plates for sale, interested?

Postby VE7LHM » Sun May 27, 2018 8:19 am

If not to late I would be interested I have a 91 Automatic.

Mr.SA
Posts: 56
Joined: Wed Mar 02, 2016 10:40 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica L300
Location: Denver

Front skid plates for sale, interested?

Postby Mr.SA » Tue May 29, 2018 5:02 pm

I'm out of them right now, I'm trying to come up with a different design thats a little easier to mount. I could do another run of these same styles if there is enough interest.

Mr.SA
Posts: 56
Joined: Wed Mar 02, 2016 10:40 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica L300
Location: Denver

Front skid plates for sale, interested?

Postby Mr.SA » Fri Jul 20, 2018 9:21 am

If i can get much interest, I'll make another run of these, my friend that was doing them before is unable to now, but i know someone else that will be able to, might just cost me a little more.

After my last run, a few people had trouble mounting them. just be aware that it will take some bending/drilling on your part to fit them. and you NEED the undertray under the engine to mount them to.

If you're interested, post your material preference, steel or aluminum, and auto or manual trans. If i get a lot of interest in aluminum i'll do some, otherwise they'll be all steel.
I'll give it a couple weeks to guage interest, then make a run based on that. so we're looking at about a month timeframe.

I'm still planning on eventually doing a super strong version, but not until i can find someone that will work with me on building them. and those will cost quite a bit more than these.


Return to “Delica Modifications”

Who is online

Users browsing this forum: No registered users and 3 guests