Delica Canada | Mitsubishi Van Club

Finally got my skid plate made up and installed




Very beefy, quite pleased with it. Those stock "splash gaurds" did more harm than good.

Do you have any details re the design and materials used? Cost?
I've been wanting to make one but haven't had the time to get down there and mock it up.

Wow that looks great, I would also like to know more info

Some more pics and measurements would be really appreciated!

Credit goes to tigweld4u, he was kind enough to post the plans online. On the UK forum. I got it built out of 3/16" aluminum, its quite solid.

Thanks for posting the diagram.
What did it cost you to have built?

Thank you kindly Islander. It looks great!

Yea quite pleased with it. It came to 400$ and that was with help installing. If I had have done the install alone it would have been about 275$

I'm thinking about using a section of conveyor belt from a coal mine, thick and pretty much rock proof, somewhat flexible. It's a bitch to cut though, but with it being somewhat flexible I won't need any fancy bends

Do you have any photos taken from a little bit further back?

side exit exhaust I see back there??

can we see some more photos of the skid plate taken from a little bit further away

and that exhaust?

Yes that is a side exit exhaust, its 2.5". Ill post up some pics tomorrow.

I cant seem to get a picture that shows the exhaust or skid plate any better. I needed a new exhaust, for the same price as getting a stock muffler I was able to go with a custom 2.5" side exit exhaust. Happy with it, wish the shop had have replace the exhaust up to the turbo but what can you do.

do you have a LWB, cause on my SWB it looks like it will be close to the electrical connectors on the rear heating unit

It is kind of close, maybe 6" away or so at one point. I do have a LWB.