Delica Canada | Mitsubishi Van Club

firm believer in if you dont have anything to hide there is no sense in hiding

I will try hard to be there. Things I would like to learn would be, why my turbo sucks so hard!
Look forward to seeing every one, its been almost 2 years since my last meet!

im assuming this procedure will work on the door seal as well? if its raining hard i get a river on my right shoulder. iv tried siliconing because i thought the rubber was peeling off, but i think its also lost its spongeness.

dammit jesse now you got me all excited to spend money i dont have! haha are these improvements not seen with one of the cheaper rebuilds. obviously it wont be nearly as good, but certainly better then with out nay type of TLS. i would also be interested in some names of some good turbo rebuild shop...

$700 to rebuild? how much are they brand new!

i hope i dont need to go down this road, but knowing my delica i probably will :(

i deff got a lemon of a gauge as it says it start to read at 200f and actually only starts at 400f!

lrp374 what does your pyrometer read at 80 km/hr?

Thanks

thanks guys, yeah i was reading into the adjustment. i was just alittle concerned as to how it could be reading so low. perhaps my turbo is on its way out? ill quickly attach a lower reading boost gauge and compare. however, i remember when my engine was being frankenstiened back together at CVI, Bu...

alright im gonna change the direction of this threat now (title still fits) so im reading all over the forum tonz of boost pressure and pyro temps that differ from my own. as stated earlier i have the glow shift 3 in 1 gauge combo seen here. http://www.glowshiftdirect.com/3in1-Combination-Gauge-Boos...

in the end i shifted things around abit and it was just long enough the way it came

if im not mistaken, is that adrocks old ride?
like the slide out idea too!

any ideas where to tap in with the sensor for oil temp??

nice, well iv checked two of those off. however, my spare sensor is for temperature, so if you were to install another temp gauge would it be for coolant, oil or tranny fluid?

i have an EGT (same thing as pyro) installed already. this sensor would measure temperature NOT pressure. i usually wouldn't bother installing any of these three, but it came with the combo and i don't want to just leave the digital screen blank

As a couple people know i bought one of glow shifts 3 in 1 gauge combos. i currently have the boost and pyrometer installed (the pyro wires ended up just reaching for people that read the other post) anyways, now i need to make a choice of the third gauge reading oil, coolant or transmission tempera...

-yeah i drilled the manifold pretty close to where yours is located, but the i got a little sloppy in the end with the drill and now im having trouble threading in the bung. im sure i will get it to fit! -thats the first iv heard of pyrometers wiring being pre calibrated tonydca? does any one else k...